JLS Power Brush System Cleaning Solution

Name: JLS Power Brush System Cleaning Solution
SKU: 113090
Availability: InStock

$15.50

Perfect solution for cleaning, brightening and putting a beautiful satin finish on the inside of instrument tubing. No harsh chemicals.

Average of 12 fl oz.

In Stock

SKU: 113090 Categories: JLS Power Brush System, JLS Power Brush System

Description

The JLS Power Brush System

The System

The JLS Power Brush System is a method for cleaning the inside of metal instrument tubing and producing a satin finish.

The Products

JLS Power Brushes

These brushes fit different sizes of tubing – all designed to use under power (with a pneumatic hand-held die grinder or a cordless drill).

JLS Cleaning Solution

This solution is a thin paste that helps clean the inside of the tubing and leave a satin finish.

The surfactant within the solution provides lubrication for a mild abrasive which helps remove dirt, grease and deposit buildup (including lime deposits that come from saliva).

After cleaning the instrument, it can easily be rinsed away with water.

More Info

Working with Other Cleaning Methods

This system is best used in combination with either the traditional acid-dip or the ultrasonic methods of cleaning, but it can also be used exclusively by itself as an alternative method.

If using with the other cleaning methods, it’s best to do so after those methods have been applied.

The cleaning solution can only be applied as far as the brush can reach, so it works best on straight tubing.

About The Satin Finish

With the traditional acid-dip method, the acid may slightly etch the tubing, whereas the ultrasonic method does not affect the finish.

Using our system will provide a satin finish, which is best for holding oil, allowing it to work well with lubricants used on slide tubes.

Instructions

We recommend following the below steps over a tub or utility sink. Please wear protective safety goggles when performing these steps.

Dip the tip of the brush in our JLS Power Brush Cleaning Solution.
Place the brush in a pneumatic hand-held die grinder or cordless drill.
Insert the brush inside the tubing.
Start spinning the brush (under power) and use a back and forth motion to brush the inside of the tubing. Caution: Do not start spinning the brush until it’s inside the tubing.
Rinse the tubing with water.