JLS High E Facilitators (for Domed Retaining Washers)

Name: JLS High E Facilitators (for Domed Retaining Washers)
SKU: 188743
Availability: InStock

$6.75

In recent years, some flute manufacturers have started using domed retaining washers on their flutes.

While these produce great results, they can interfere with High E facilitators if installed at a later point in time, as the retaining washer protrudes further.

This new line of High E facilitators is thinner and features a wider center hole than our standard line to accommodate the new domed retaining washers.

Flute Makes with Domed Retaining Washers:

DiZhao
Muramatsu
Tomasi
Sonare
Amadeus

For installation directions, see the description below.

SKU: N/A Category: Flute High E Facilitators

Description

Our High E Facilitator (a.k.a. “donut” or poor man’s split-E) is an option that may help tame the high E on the flute. This note can be problematic, as it tends to respond stubbornly and sound stuffy and out of tune. Our easy-to-install, pre-made high E facilitators can be glued into the lower G tone hole with 5-minute epoxy. Available in white delrin.

How to Install a High E Facilitator:

Step 1: Measure the inner diameter of the lower G tone hole to select the correct size high E facilitator. The diameter of the facilitator should fit the hole securely as possible without being tight.

Step 2: Insert your flute body mandrel into the bore of the instrument. Please ensure that the mandrel is clean and polished, and wipe the bore first. We don’t want to create any scratches.

Step 3: Wearing your gloves, mix up some 5-minute epoxy and apply a small amount to the edge of the high E facilitator with a toothpick.

Step 4: Set the high E facilitator into the tone hole (make sure it’s the correct hole). Make sure that the saddle-shaped side is fitting down on the mandrel and that the facilitator as a whole sits below the edge of the tone hole. The mandrel serves as an alignment tool and as a stop when inserting the high E facilitator.

Step 5: Clean up any excess glue residue quickly before it sets. After a minute, pull the mandrel out. Let the glue set up for half an hour then reassemble the instrument. Remember to take the keys off the flute before shoving the high E facilitator in.